Figure 6a: Proper alignment

Figure 6b: Compression anchor too tight? Opening width too small?

Figure 6c: Screw installed in gusset prior to tightening of compression anchor? Opening width too large?

Figure 5b: Place 2 framing squares in
the rabbets. Check alignment
with a straight edge. They should be even.

Figure 5a: CCompare measurements from each rabbet.
If they are di!erent the frame is twisted.

Field Troubleshooting fig 5

Field Troubleshooting figures 3-4

Troubleshooting figures 1-2

Figure 1: Measure both rabbets